Descargar Imprimir esta página

Sears Kenmore 106.7200 Manual De Uso Y Cuidado página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

Dispensing
Water
1.
Hold
a container
under
the dispenser
while
pressing
the button.
2.
Release
the
button
to stop
dispensing.
3.
Remove the sealing
label from the end of the new water
filter
and insert the water
filter
into the filter
mounting
bracket.
Gently
rotate
the water
filter
clockwise
until it stops, and snap
the filter cover closed.
The water
filter
is located
in the upper
right-hand
corner of the
refrigerator
compartment.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water
Filter
Status
Indicator
Models
The disposable
water filter should
be replaced when the
Replace
light is lit, or at least every 6 months. If the water flow
to the water
dispenser
or ice maker decreases
noticeably
before
6 months
have passed,
replace
the water
filter
more
often.
After replacing
the water
filter, press and hold the Filter Reset
touch pad for 3 seconds until the Order
or Replace
light turns
off. See "Using
the Controls."
Non-Indicator
Models
The disposable
water filter
should
be replaced
at least every
6 months. If the water flow to the water
dispenser
or ice maker
decreases
noticeably
before 6 months have passed,
replace
the
water
filter
more often.
Replacing the Water
Filter
IMPORTANT:
Air trapped
in the water
system may cause water
and filter to eject. Always
dispense
water
for at least 2 minutes
before
removing
the filter or blue bypass
cap.
1.
Turn the used water filter
counterclockwise
until it releases from
the filter
mounting
bracket.
2.
Drain water
from the water
filter
into the sink, and discard
the
used water
filter. Wipe
up the excess water in the filter
cover.
4.
Flush the water
system. See "Water
System Preparation."
5.
Inspect the water filter
system for leaks. If you see water
leaks,
see "Troubleshooting."
Using the Dispenser Without
a Water
Filter
You can use the water
dispenser
without
a water
filter,
but your
water
will not be filtered.
If you choose this option,
replace
the
water
filter with the blue bypass cap.
IMPORTANT:
Flush the water
system before
turning
on the ice
maker.
See "Water
Dispenser."
Turning the Ice Maker
On/Off
To turn the ice maker ON,
simply
lower the wire shutoff
arm.
To manually
turn the ice maker
OFF, lift the wire shutoff
arm to the
OFF (arm up) position
and listen for the click.
NOTE: Your ice maker
has an automatic
shutoff.
As ice is made,
the
ice cubes will fill the ice storage
bin and the ice cubes will raise the
wire shutoff arm to the OFF (arm up) position.
Do not force
the wire
shutoff
arm up or down.
NOTE:
Turn off the ice maker
before
removing
the ice storage
bin
to serve ice or to clean the bin. This will keep the ice cubes from
dropping
out of the ice maker and into the freezer
compartment.
After
replacing
the ice storage
bin, turn on the ice maker.
Ice Production
Rate
The ice maker
should produce
a complete
batch
of ice
approximately
every 3 hours.
To increase
ice production,
lower the freezer
and refrigerator
temperature.
See "Using
the Controls."
Wait
24 hours between
adjustments.
15

Publicidad

loading

Este manual también es adecuado para:

Kenmore 106.7201