Publicidad
Idiomas disponibles
Idiomas disponibles
_i ec_:s" _ _,;_t __!eq_,_
_eme_'_'s_,,
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death_
fire_ or electrical shock.
Before
you move your refrigerator
into its final
location,
it is
important
to make sure you have the proper
electrical
connection.
Recommended
Grounding
Method
A 115 Volt, 60 Hz., AC only 15- or 20-amp
fused, grounded
electrical
supply
is required.
It is recommended
that a separate
circuit
serving only your refrigerator
be provided.
Use an outlet that
cannot
be turned off by a switch.
Do not use an extension
cord.
NOTE:
Before performing
any type of installation,
cleaning,
or
removing
a light bulb, turn Cooling
OFF, and then disconnect
the
refrigerator
from the electrical
source. When
you are finished,
reconnect
the refrigerator
to the electrical
source and turn Cooling
ON. See "Using
the Controls."
Gather
the required
tools and parts before
starting
installation.
Read and follow
the instructions
provided
with any tools listed here.
TOOLS
NEEDED:
•
Flat-blade
screwdriver
•
1/4" Nut driver
•
7,_6" and 1/2" Open-end
or two
•
1/4" Drill bit
adjustable
wrenches
•
Cordless
drill
IMPORTANT:
•
All installations
must meet local
plumbing
code
requirements.
•
Do not use a piercing-type
or 3_6" (4.76 mm) saddle
valve
which reduces
water flow
and clogs more easily.
•
Use copper
tubing
and check
for leaks. Install copper
tubing
only in areas where the household
temperatures
will remain
above
freezing.
•
For models
with water
filters, the disposable
water
filter should
be replaced
at least every 6 months.
Water
Pressure
A cold water
supply with water
pressure of between
35 and 120 psi
(241 and 827 kPa) is required
to operate
the water
dispenser
and
ice maker.
If you have questions
about
your water
pressure, call a
licensed,
qualified
plumber.
Reverse
Osmosis
Water
Supply
IMPORTANT:
The pressure of the water
supply coming
out of a
reverse osmosis system going
to the water
inlet valve of the
refrigerator
needs to be between
35 and 120 psi (241 and
827 kPa).
If a reverse osmosis water
filtration
system is connected
to your
cold water
supply, the water
pressure to the reverse osmosis system
needs to be a minimum
of 40 to 60 psi (276 to 414 kPa).
If the water
pressure to the reverse osmosis system is less than 40 to
60 psi (276 to 414 kPa):
•
Check to see whether
the sediment
filter in the reverse osmosis
system is blocked.
Replace the filter
if necessary.
•
Allow the storage
tank on the reverse osmosis system to refill
after
heavy usage.
•
If your refrigerator
has a water
filter, it may further
reduce
the
water
pressure when used in coniunction
with a reverse osmosis
system. Remove the water filter.
See "Water
Filtration
System."
If you have questions
about
your water
pressure, call a licensed,
qualified
plumber.
6
Publicidad
