Widex TV PLAY Instrucciones De Uso página 225

NOTE
If your TV doesn't have a USB socket, you can use a standard USB wall charger (not inclu-
ded). The wall charger should supply at least 500 mA (2.5 W) of power.
Setting up the device for one or two hearing aids - see illustration 5
You can set up your device according to your needs using the slider on the bottom of
the device. If you have one hearing aid, choose the monaural setting, and select the
binaural setting if you are using two hearing aids.
Pairing the device with your hearing aids - see illustration 6
You need to pair your device and hearing aids before you start streaming sound from
your TV. Do as follows:
1. Power your device by turning on your TV (see illustration 4) or consult the "Pow-
ering the device" section.
2. Restart your hearing aids by opening and closing the battery compartment.
3. Keep the hearing aids in range of the device while pairing (3-6 feet).
4. The hearing aids play a tone confirming that they have been paired with the de-
vice.
NOTE
Your hearing aids are only in pairing mode for three minutes after you restart them.
You might need to restart them again if you didn't pair them in time.
NOTE
The device can be used to stream sound to more than one user at a time. If you need
this option, simply follow the same pairing procedure above.
Removing a pairing
You can only remove a pairing using the App. To do so, follow these steps:
1. Open the TV PLAY program on your App, and then enter the Sound Menu.
2. Tap the three dots on the top right corner of the Sound Menu.
3. Press the Delete pairing button and accept deleting a pairing.
Mono sound
Stereo sound
225