Connections To Be Made - Axxess AX-CH5-SWC Instrucciones De Instalación

Attention! This interface will work with models that are either factory amplified, or non-amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in either
no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please contact
your local dealership.
For models without a factory amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AX-LCD (sold separately), there will be an accessory wire there to
connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (10) wires, they will not be used in this application:
Blue/White, Brown, Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White and
White/Black.
2

CONNECTIONS TO BE MADE

From the AX-CH5-SWC harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Disconnect the (2) 4-pin connectors that have Green, Green/Black, Purple, and Purple/Black wires.
• Connect the 4-pin harness with stripped leads to the 4-pin connector from the gray 22-pin
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera input.
• If the AUX-IN jack in the dash is desired to be used, connect the Red and White RCA jacks to
• The DIN jack is to be used with the optional AX-LCD (sold separately) to retain the
connector.
the audio AUX-IN jacks of the aftermarket radio.
personalization features of the vehicle.
• Connect the Red wire to the accessory wire.
Continue to 3.5mm jack steering wheel control retention