OKBABY Body Guard Manual Del Usuario página 35

Chapter 6 Child's bicycle seat OKBABY BODY GUARD
Figure 6:
Insert the two ends of the support
arm (4) into the fastening block holes
(7).
DANGER! Pull the support arm
upwards to check that the child seat is
firmly in place and held by the faste-
ning block.
Figure 7:
Adjust the vertical position according
to the parameters shown in the dra-
wing.
If the child seat is too high or too low,
loosen the screws (8) on the fastening
block and adjust the height. Use the
centre-point mark (21) printed on the
child seat to achieve the correct hori-
zontal position.
To adjust the horizontal position of
the seat, position the support arm
(4) in one of the three slots under
the child seat base (Fig. 2). When the
seat is correctly in place, tighten the
screws (8) slowly and evenly until the
fastening block stops rotating around
the frame. Slide the front cover (17)
over the front part of the block.
Cover the fastening counter-block (6)
with the protection cover (10).
DANGER! Once you have placed
the child in the seat, check to see that
the seat is slightly inclined backwards
to prevent the child from slipping for-
wards and sliding out of the seat.
Instructions for use and assembly
Page 68
4
7
6
21
6-7 cm MAX
10 cm MAX
7
LIB093R01EU Edition: 03-2010
Chapter 6 Child's bicycle seat OKBABY BODY GUARD
Figure 8:
Insert the foot straps (19) into both
of the footrests passing them through
the widest part of the external slot (a)
to the internal slot (b).
Figure 9:
Fastening the footrests:
Fasten the footrests (15) by inserting
them in a position higher than its
shaped seat, passing the widest part
of the foot strap through the slit on
the leg of the child seat (fig 9A).
Position the right footrests, into the
slot on the right of the seat and vice
versa. For each footrest, insert the
regulating pin (16) from the outside
of the seat towards the inside, making
sure that the right pin meets the right
side and vice versa.
ATTENTION! Both the pins,
footrests and the sides of the child
seat are marked as follows : DX=right
and SX=left.
Figure 10:
Extracting the footrests:
To extract the footrests, turn the
regulating pin (16) upwards, move the
footrest (15) upwards as far as pos-
sible, open the foot strap and pull the
regulating pin lever outwards to free
the support.
Instructions for use and assembly
Page 69
DX
b
a
8
15
DX
16
9
9A
16
10
LIB093R01EU Edition: 03-2010