Chapter 2. Connection; Mounting Wireless Imager - Sanyo POA-WL11 Operación Manual

Chapter 2.

Chapter 2. Connection

2.1. Mounting Wireless Imager

[CAUTION] Before mounting Wireless Imager, be sure to disconnect the projector's power plug
1. Remove 4 hole covers from the projector. Align and insert Wireless Imager's mounting hooks (A),
as shown in Figure 1.
2. With pressing Latch Button to the direction of the arrow, insert Wireless Imager's Connector Plug
into the Projector's DVI terminal. Press Wireless Imagers gently against the projector to firmly
secure the unit into place. Release your hand when Wireless Imager is properly mounted.
Figure 1
Align Switch
Button here
Connection
from AC outlet. Do not mount Wireless Imager to the projector while its power plug
is connected to AC outlet. It may result in damaging the device.
A
[ ]
DVI Terminal
COMPUTER IN
DVI - I
R – AUDIO IN – L
S – VIDEO
MCI / WI
MONITOR OUT
Latch Button
VIDEO
(MONO) Y – Pb / Cb – Pr / Cr
AUDIO IN
R – AUDIO OUT – L
COMPUTER
RESET
USB CONTROL PORT
Connector Plug
— 18 —
Hole cover
Remove 4 hole covers
Figure 2