Advanced Setup - Admin Password - Sanyo POA-WL11 Operación Manual

4.3.5. Advanced setup – Admin Password
On Admin Password setup screen of the advanced setup, an admin password can be set so that
personnel other than the system administrator cannot change the set contents of Wireless Imager. With
the factory default settings, this password is not set.
[NOTE] Always record the password you have set. If you forget the password, you must initialize
all settings of Wireless Imager. (See [1.5. Factory default Settings].)
After setting an admin password, you will be prompted to enter the password whenever
you change the device settings via the web browser or WI Set. You will not need the
password when the settings are changed from the projector menu.
Parameter
Enter Current Admin Password
Enter New Admin Password
Re-enter New Admin Password
[NOTE] If you set the admin password for the first time, you do not input any password in the
[Enter Current Admin Password] field. Enter a desired password in [Enter New Admin
Password] and [Re-enter New Admin Password] fields.
You can assign respective user password for three different LAN environments (LAN 1 to
LAN 3), but the same Admin password will be used for all three LAN settings.
Chapter 4.
Input the currently set admin password. The password you have
input is shown like "●●●●●●●".
Input a new admin password you wish to set. The password you
have input is shown like "●●●●●●●".
Re-enter the new admin password you wish to set. The password
you have input is shown like "●●●●●●●".
— 39 —
Setting up Wireless Imager
Description