Change Configuration Set - Sanyo POA-WL11 Operación Manual

4.3.8. Change Configuration Set

On Change Configuration Set screen, you can select a set of desired LAN settings to be activated from
LAN 1, LAN 2, or LAN 3.
You can also check following parameter settings under each LAN settings.
● Location
● IP Configuration Method
● IP Address
● Wireless Mode
● Channel
● SSID/ESSID
● WEP Security
Check on the check box of Configuration Set (LAN 1 ~ LAN 3) you wish to activate.
If the contents you have set on this page are correct, click the [APPLY] button.
The screen prompting you to restart Wireless Imager will appear. If no other configuration change is
necessary, click the [RESTART] button to restart Wireless Imager. The changed settings will take effect
upon Restart.
[NOTE] To return the contents you have set to the previous settings, click the [REFRESH] button
before pressing [APPLY] button.
To change the setting in each Configuration Set (LAN 1 ~ LAN 3), select the desired
Configuration Set in this screen and click [APPLY]. Then, click [Back] button on the
browser menu and change the settings.
Chapter 4. Setting up Wireless Imager
— 43 —