Sanyo POA-WL11 Operación Manual página 46

Chapter 4. Setting up Wireless Imager
3. Press SELECT button to display the network configuration screen.
Using the pointer [
Use /
Use ▲ / ▼ to change the value in each field.
Parameter
IP Address
Sub net
Gateway
Current Channel
Connection Status
SSID/ESSID/IBSSID
/▲/▼/ ], move to each field and change settings.
to move to different fields.
Set the IP address in the environment you wish to use.
Set the Subnet mask in the environment you wish to use.
Set the gateway address in the environment you wish to use.
If any segment beyond the router is not used, the gateway address can be
left at "255.255.255.255".
Set the channel when the system is used in the "Pseudo AdHoc" mode.
Select from available channels in each region; North America (USA and
Canada): 1 ~11; Europe: 1~13; France: 10~13.
Set the wireless communication mode in the environment you wish to use.
Select either "Infrastructure" or "AdHoc".
"AdHoc" provides "Pseudo AdHoc" and "802.11 AdHoc". A desired AdHoc
mode is set using the DIP switch on Wireless Imager unit. (For details, see
[1.4. Part names and functions of main unit] in Chapter 1.)
Additionally, pressing the TEST switch on Wireless Imager can check
what mode is currently set. (For details, see [1.4. Part names and
functions of main unit] in Chapter 1.)
Set SSID/ESSID when the system is used in the "Infrastructure" or
"802.11 AdHoc" mode.
[NOTE] If a SSID/ESSID, other than "ANY", is to be used in Infrastructure
mode, the same SSID must be set to Wireless Imager, access
point, and the wireless-enabled client PC.
In 802.11 Adhoc mode, the same SSID must be set to Wireless
Imager and the wireless-enabled client PC.
SSID/ESSID is case-sensitive. Even though all characters
projected by pressing the TEST switch on Wireless Imager are
uppercase, it is necessary to discriminate between upper and
lower case characters.
Description
— 46 —