Main Menu; Languages Menu; Status Menu; Settings Menu - HellermannTyton AT2000 CPK Manual Del Usuario

7.2 Start menu
f Switch the AT2000 CPK ON, à "Switching on" on
page 11.
; Wait approximately 5 seconds for the Start menu to
appear on the display.
Menu
1
1
2 Reset
3
4
5
; The green highlight indicates the current force level
7.3

Main menu

Bindings cannot be triggered while you are navigating in the
main menu. The S i g n a l LED on the power pack shows blue.
f Press the Enter button.
; The
M a i n m e n u appears on the display.
Main menu
Languages
Status
Settings
Contact
Back
7.4

Languages menu

You use the L a n g u a g e s menu to select the language for
the menus.
Languages
Deutsch
English
Italiano
Français
Türkçe
Polski
Español
f Use the Select button to select the language.
f Press the Enter button.
; The display switches to the language you selected.
7.5

Status menu

Status
Counter reading 00000001
Tool software 1.38- 8
Power-pack SW 1.07
Serial number 00000013
Temperature 26
Humidity 32
Last service 23 Jan 2017
Cntr.rdng.lastSer 0000000
The S t a t u s menu shows you the following status
readings.
• Counter reading
• Software version of the tool (Tool) and an index number
for the language version
Operating Instructions • AT2000 CPK • 02-2017 • v02 • 106-29004
• Software version of the power pack
• Serial number of the tool
• Ambient temperature and humidity
• Date of last service
• Counter reading at last service
7.6

Settings menu

You use the S e t t i n g s
of the AT2000 CPK.
Access to the S e t t i n g s
access code that can be changed in the HT Data Management software, à "Changing the access code in the
.
1
AT2000 CPK" on page 18. The default access code is
f Use the Select button
S e t t i n g s menu.
f Press the Enter button.
; The prompt for the access code appears on the display.
Settings
Access code 0 0 0
f Use the Select button to enter each digit of the access
code.
f Press the Enter button to conirm each digit.
; The
S e t t i n g s menu appears on the display.
Settings

Force level

Quality
Interruption front sensor
Date / time
Check of binding
Back
7.6.1 Force level
The setting corresponds to the force applied
F o r c e l e v e l
by the AT2000 CPK when binding, and it can be set
from Level 1 (lowest force) to
Settings
Force level
Level 1
Level 2
Level 3
Level 4
Level 5
Back
f Use the Select button to select the force level.
f Press the Enter button.
; The setting changes to the level you selected.
Service menu
menu to set important parameters
menu is protected by a three-digit
to select the
in the M a i n m e n u
Level 5 (highest force).
0 0 0 .
13