Cognex In-Sight VC200 Manual página 11

Connect the ISC-7800 Series Camera
The ISC-7800 series camera's PWR connector supplies power to the camera and
provides access to the camera's acquisition trigger and strobe output. The camera's
ENET connector provides an Ethernet connection. Refer to the ISC-7800 Series
Camera Reference Guide for complete camera installation steps and specifications.
CAUTION: Cognex recommends only cold-plugging the camera; turn the
vision controller power off when connecting or disconnecting the camera.
1. Verify the camera's 24VDC power supply being is unplugged and not
receiving power.
2. Optionally, connect the Breakout cable's I/O wires to an appropriate device
(for example, a trigger sensor or strobe light).
Note: I/O wiring or adjustments to I/O devices should be performed
when the camera is not receiving power.
10