Cognex In-Sight VC200 Manual página 29

3. Insert the power supply's +24VDC (Power) wire to Pin 1 and the -24VDC
(Return) wire to Pin 2 on the power connector. Connect a frame ground
wire from Pin 3 to frame ground. Recommended wiring is 14 - 18 AWG,
solid or stranded wire.
CAUTION:
power connector. Connecting AC power will damage the vision
controller.
4. Tighten the wire retention screws to secure the wire leads in the terminals;
the maximum torque is 0.6 Nm (5.3 in-lb).
Do not connect AC power directly to the vision controller's
28