Cognex In-Sight VC200 Manual página 17

Connect the DS900 Series Sensor
The DS900 series sensor's Ethernet connector provides an Ethernet connection
and Power over Ethernet (PoE) to the sensor. The sensor's multifunction port
provides access to I/O connections.
WARNING: The DS900 series sensors are designated as a Class 2M laser
product. These laser products can be hazardous. Please refer to the DS900
Series and DS1000 Series Sensor Reference Guide for important instructions
on their safe use.
CAUTION:
Cognex recommends only cold-plugging the sensor; turn the vision
l
controller power off when connecting or disconnecting the sensor.
The vision controller's CAM ports provide Power over Ethernet (PoE)
l
to supported Cognex devices; connecting other PoE devices to these
ports could damage the vision controller or the PoE device.
1. Optionally, connect the terminated end of the Multifunction cable to the
DS900 series sensor's Multifunction port. Connect the I/O wires to the
applicable I/O device.
CAUTION:
flying lead wires must not be connected to any external point or to
each other.
2. Connect the Ethernet cable's M12 connector to the DS900 series sensor.
The Multifunction cable's PWR (Red) and GND (Blue)
16