Cognex In-Sight VC200 Manual página 5

Precautions
Observe these precautions when installing the vision controller to reduce the risk of
injury or equipment damage:
The vision controller is intended to be supplied by a NRTL listed power
l
supply with a minimum output rated 24VDC, 3.5A and must be used with
the Cognex-supplied 24VDC power connector. Any other voltage creates a
risk of fire or shock and can damage the components. Applicable national
and local wiring standards and rules must be followed. Wire and
connections must be in accordance with these instructions, the National
Electrical Code and applicable national and local wiring standards and rules.
To reduce the risk of damage or malfunction due to over-voltage, line noise,
l
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
Do not install Cognex products where they are directly exposed to
l
environmental hazards such as excessive heat, dust, moisture, humidity,
impact, vibration, corrosive substances, flammable substances, or static
electricity.
The In-Sight vision controller does not contain user-serviceable parts. Do
l
not make electrical or mechanical modifications to In-Sight vision controller
components. Unauthorized modifications may void your warranty.
Changes or modifications not expressly approved by the party responsible
l
for regulatory compliance could void the user's authority to operate the
equipment.
Service loops should be included with all cable connections.
l
4