Porsche Mobile Charger Connect Manual Del Propietário página 22

Setup
In some countries, e.g. in Norway, Italy, Portugal and
Spain , the supply cable must only be changed by a
1
qualified electrician. Porsche recommends that you
use a certified Porsche service partner.
Fig. 14 Connections on the control unit
The supply cable is removed and plugged in at the
A
top of the control unit.
The vehicle cable is removed and plugged in at the
B
bottom of the control unit.
1. Time of printing. Further information is available from your authorized Porsche dealer or your local electricity supplier.
20
Disconnecting cables
Fig. 15 Disconnecting cables
b Charging of the high-voltage battery has ended
and the vehicle plug has been removed from the
vehicle charge port.
b The plug has been disconnected from the elec-
trical socket.
1. Remove screw (Fig. 15) using a suitable tool.
C
2. Lift the lever (Fig. 15).
A
3. Pull out the plug (Fig. 15) until resistance is
B
first felt.
4. Close the lever (Fig. 15).
A
5. Pull out the plug (Fig. 15) fully.
B
Securing cables
Fig. 16 Securing cables and plugs
b The lever
(Fig. 16) is closed.
A
1. Insert the plug (Fig. 16) into the control unit
B
until resistance is first felt.
2. Lift the lever (Fig. 16).
A
3. Push in the plug (Fig. 16) fully.
B
4. Close the lever (Fig. 16).
A
5. Secure the plug (Fig. 16) to the control unit
B
using screw (Fig. 16).
C