First Use Of The Web Application - Porsche Mobile Charger Connect Manual Del Propietário

Setup
User Profiles (Pairing PorscheID)
When the charger is paired to your Porsche ID, infor-
mation about the charger and the charging processes
can be displayed in My Porsche or in the Porsche
Connect app.
To pair the charger with your Porsche ID:
e
Call up the website specified on the display on
the charger in the browser on your device and
enter the user code.
– or –
Scan the QR code displayed on the charger. You
can scan the QR code in the following ways:
–
Using the Porsche Connect app (My Ac-
count > Charging cables & devices > Scan
QR code).
– Using the camera on your device (iOS 11 or
higher, different for Android).
– Using an app for scanning QR codes.
When the charger has been paired successfully, the
Setup assistant moves on to the next step.
Connect Energy Manager
If an energy manager is available, it is possible to
establish a connection to it. The energy manager then
assumes control of the charging process.
e
For instructions for connecting, refer to the oper-
ating instructions for the energy manager.
If no energy manager is available, the vehicle will
be charged at the charging current entered on the
charger:
e e Adjust charging current
Settings
g Refer to chapter "Adjust charging current" on
page 22.
22
Hotspot
If it is not possible to integrate into a home network,
the charger can activate a hotspot, thereby estab-
lishing a connection to the web application on the
charger.
e
To activate a hotspot, click on Activate hotspot.
Once a hotspot has been activated, the symbol
will appear in the status bar.
Information
When using Android systems, the connection may
have to be confirmed separately in order for a hotspot
connection to be established.
Adjust charging current
The maximum permitted charging current for the
charger can be set here if there is no energy manager
available in the home network.
The displayed maximum value is determined by the
types of cable that are connected.
e
Set the charging current to the maximum value
available in the power grid used for the charger.
Use Plus and Minus to do this.
g Refer to chapter "Charging current limiting" on
page 25.
Device protection
To prevent an unauthorized vehicle from being con-
nected to the charger, a PIN prompt can be config-
ured.
1. To activate the PIN prompt, select On.
2. Enter a 4-digit PIN and confirm.
3. Enter the PIN again and confirm it.
�� Activation of the PIN prompt is confirmed.
Einrichtung abschließen
e
Anhand der Summary die getroffenen Einstellun-
gen prüfen und die Einrichtung abschließen.

First use of the web application

Before the charger and the Web Application can be
used for daily purposes, the charger must first be set
up. Next, a connection must be established between
the end device (PC, tablet or smartphone) and the
charger.
Requirements for the First Use of the Web
Application
You should have the following information to hand
when using the Web Application for the first time:
–
Letter containing access data Porsche Mobile
Charger Connect for logging into the charger's
web application
–
Access data for your domestic network
–
Access data for the user profile (to link it with
the Porsche ID)