Operation; Control And Display Elements; Display Elements During Initial Commissioning - Grundfos Conex DIA-2Q Manual De Instrucciones

11. Operation

11.1 Control and display elements

1 6
Fig. 25 Wall-mounted enclosure and control panel enclosure
Pos. Description
Control elements
Red alarm LED
1
• Flashes in case of faults or incorrect
entries.
2 Display
Operating buttons
[OK] button
3 • Enters the selected menu.
• Confirms the selected line or value.
[Down] button
• Moves one line downward (the selected
4
line is displayed inversely).
• Decreases values.
[Up] button
• Moves one line upward (the selected line
5
is displayed inversely).
• Increases values.
[Esc] button
• Returns to the previous menu.
6
– The data which were entered last are
not changed.
Function buttons with yellow LED
[Cal] button
• Switches between calibration mode and
7 measuring mode.
– In calibration mode, the corresponding
LED illuminates.
[Man] button
• Switches between automatic and manual
8 modes.
– In manual mode, the corresponding
LED illuminates.
26
5 4 3 2
2
6 5 4
7 8
11.2 Display elements during initial
commissioning
When connected to the power supply on the device's
initial commissioning and following the start-up
indication, the display shows the "Sprache/language"
menu.
Language/Langue...
Deutsch
English
Français
Nederlands
• The word "language" in the header is displayed in
all available languages successively at intervals
of approximately one second.
®
Start the Conex DIA-2Q by selecting the desired
operating language:
1. Select the desired language using the [Up] and
[Down] buttons.
– The selected language is displayed inversely
(white letters on black background).
2. Press [OK] to confirm.
The selected language is stored and will
remain the operating language when the
device is rebooted. If necessary, the
Note
operating language can be changed in the
"language" submenu in the "setup" menu.
See section
7 8 1
3
11.5 Setup.