Grundfos Conex DIA-2Q Manual De Instrucciones página 40

11.6.3 Controller control fields on the display
1. Press [Esc] once or twice to switch to the display
"measured value".
See sections 8.2 General data
modes.
chlorine
0.43
mg/l
5.20 pH
22 °C
Fig. 34 Chlorine measurement with pH and temperature compensation
• The display with the measured value always
refers to the measuring range 0-20 mA.
Depending on the current input (proportional or
disturbance variable), it is displayed unfilled or
partially to completely filled (inverted font in latter
case).
Unfilled (at 0 mA):
Partially filled (at 0 < x < 20 mA):
Completely filled (at 20 mA):
• The control fields for relays 1 and 2 appear as
follows for configured limit monitors/two-position
controllers:
Unfilled field for relay off:
1
Filled field (displayed inversely) for relay on:
1
40
and 11.2.1 Display
1
1
relay 1 or 2
c
control fields for pH or temperature
c
pH-meas. value,
temp.-meas value
"c" = compensation on
controller control fields
continuous controller output
proportional disturbance variable
• The control field for the continuous controller is
empty, partially filled or completely filled
depending on the set dosing rate - and when
configured accordingly - and the filling of the bar
always refers to 100 % of dosing rate.
Example:
0 %:
50 %:
100 %: