Control Panel Lock; Lost Panel Lock Code; Adjusting The Brightness Of The Display; Quick Smart" Mode (Essential Functions) - Jacuzzi Mood S Manual De Uso Y Mantenimiento

Control panel
Lost panel
Adjusting the brightness
of the display
"Quick Smart" mode
(essential functions)
The mode is turned on/off
using an access code
To exit the setting menu without stor-
ing the access code, press the

Lost "Quick Smart" code

This function is used to limit access to the control panel with a 4 digit code.
lock
Select the symbol corresponding to "extra settings"
proceed as described to change the pre-set code (0000) with the preselected one: once
the last number is entered, the display shows the start-up menu and the lock is activated.
The code must be entered each time you want to use the control panel.
The heater and the light can be turned off even if the control panel is locked.
Turn the knob: a request appears to enter the access code.
lock code
Then press the knob in correspondence of the first number: the cursor will move to the
next number.
At this point, hold down the knob until the first two numbers turn green and the cursor
moves below the third number (keep holding down the knob).
When all the numbers turn white (after approx. 40 seconds) press the knob again in
correspondence of each number; when the operation is complete, the display shows the
start-up menu and the code is removed.
Select the symbol corresponding to "extra settings"
it is possible to adjust the brightness of the display according to 3 brightness levels.
This mode makes it possible to enable the display or set only the parameters essential to sau-
na operation, i.e.:
- heater on/off;
- sauna light on/off;
- heater operation selection (Finnish or bio sauna, if available);
- adjustment of the temperature and/or relative humidity (models with bio sauna only).
Select the symbol corresponding to "extra settings"
symbol appears and select it; when the 4 digit code appears
for entering the preselected code.
Once the last number is entered, the display shows the start-up menu and the "Quick
key
Smart" mode is activated.
To deactivate the "Quick Smart" mode, select the symbol
and enter your access code.
Turn the knob until the
Hold down the knob (approx. one minute) until the request to enter the code appears.
Press the knob again in correspondence of each number; when the operation is com-
plete, the display shows the start-up menu and the code is removed.
45
symbol appears.
and then the symbol ;
and then the symbol : here
, turn the knob until the
proceed as described above
(as previously described)
then