5. Preparing for pumping
WARNING
• Only use the power cord that comes with the Symphony breast pump.
• Make sure the voltage of the power cord is compatible with the power source.
i
Information
Optional for pump with battery:
• The built-in battery must be charged for 12 hours on receipt of the device.
• The pump can be used during charging.
• If the pump is to remain unused for a long time, charge the battery every two months
(for 12 hours each time).
• The optimum service life of the battery is achieved if it is not fully discharged on a regular
basis or if the pump is charged while not in use
Pumping time (fully charged battery):
approx. 60 minutes
Charging time (for full charge):
12 hours
5. 1 Installation of the program card
5.2 Installation of the card and cord protector (optional)
1. The program card must be inserted in the card
compartment on the back of the breast pump.
Æ For more information on the use of the program
card and the selection of the appropriate program,
see section 6.2.
1. Insert the cord into the card and cord protector
in a loop around the pin.
Æ Ensure that there is sufficient cord length to insert
the power cord into the power socket in the back
of the pump.
15