Publicidad
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the rear tailgate and
remove both of the taillight
housing assemblies. Separate the
taillight connectors while being
careful not to damage the locking
tabs. There will be connectors
on the vehicle harness similar to
those on the T-Connector.
3. Beginning on the left (driver's) side route the
T-Connector harness ends with the yellow wires up from
under the vehicle and out through the opening for the taillight
housing.
4. Inspect the vehicle connectors for dirt and debris clean if
neccesary. Plug the T-Connector containing the Yellow wire
between the separated vehicle harness connectors. Press the
T-Connector ends firmly into the vehicle harness connectors
until they lock into place. Take care not to damage the
locking tabs.
5. Locate an appropriate position on the vehicle frame to
attach the grounding screw. Clean away any dirt or debris
and drill a 3/32" hole.
Caution: Do not drill into any exposed surfaces or
through the vehicle body.
Fig. 1
Publicidad
