Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
- The appliance must not be switched on when the container (3) has no liquid (e.g.
water, juice, etc.)
- Place the lid (2) and the plug (1) in the position.
- Switch on the blender with the switch (A)position "ON", and then set the speed with the
knob (B). The speed should be adjusted to the food products in the container.
- Pulsating work is possible after the switch (C) is shifted to position "I" and held. Released,
the switch automatically returns to position "O".
- The pusher (7) may be used to slide the products to the blade.
The pusher (7) may be used only when the lid (2) is placed on the container (3).
- The maximum time of continuous work of the appliance is 1 minute. If this time is
exceeded, immediately switch off the device and wait at least 5 minutes before its
restarting.
- Exceeding the maximum time of work may result in damaging of the device and loss of
the guarantee.
- Before removing the container from the motor body, make sure that the appliance is
switched off (the switch (A) is in position "OFF")
NOTE.
If the blade is jammed, immediately switch off the blender, disconnect it from the
network and leave the device to cool down for at least 15 minutes. Eliminate the
cause of jamming.
RECOMMENDATIONS
To prevent splashes, do not fill the jug above the mark of the 1500 ml level.
- If liquids are processed that foam or expand during mixing, do not fill the jug to a level
higher than 2/3 of the maximum volume.
- To achieve the best results in preparing mush and puree, place small portions to the
container instead of large ones.
- In case of processing solid products, first cut them into smaller bits (2-3 cm).
- When using the blender, always keep your hand on the cover of the device.
- Be cautious when mixing hot liquids.
- To mix ingredients of solid consistence, using the blender in the pulse mode is
recommended to prevent jamming of the blades.
CLEANING AND MAINTENANCE
Simple cleaning of the container:
- Empty the container and fill it with water.
- Place the container on the motor body and turn the switch (C) several times to the "P"
position.
- Pour out the water from the container and wash it.
Thorough cleaning
- Clean the device right after its use.
- Before cleaning, switch off the device, remove the plug from the socket and wait for the
blade to stop rotating.
11 EN
Publicidad
Tabla de contenido
