Functions; Preparation For Training - Ambu SAM Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 34

3. Functions

3.1 Hygienic System (see picture ①)
Schematic diagram:
The head bag has been mounted in the skull and the face piece fitted. Ventilation has just
started, see picture 1.1.
A: Trainee's air B: Ambient air
Ventilation is concluded and expiration has just started, see picture 1.2.
NOTE: If a leakage occurs around the mask or if insufflation proves difficult, it is normally
due to incorrect positioning when lifting the chin or to insufficient hyperextension of the
head.
To comply with the requirements of the hygienic system, and to achieve a proper seal and
accurate measuring results, a head bag must always be used.
All trainees must use their own face piece and head bag only during training.
3.2. Compression indicator
The compression indicator shows the correct depth of the chest compression.
When compressing the chest of Ambu SAM the indicator will show a red bar until the
correct depth is reached. Once the correct depth is reached the indicator will change into
a green bar. If the compression is continued too deep the indicator will change back into a
red bar.
The compression indicator will show a green bar at a compression depth of 5cm to 6 cm.

4. Preparation for training

The Ambu SAM training manikin is supplied in a carry bag. To start the training remove
the manikin from the bag.
4.1. Mounting the head (see picture ②)
When the manikin is stored the head is placed inside the manikins and the neck if folded
down.
Pull out the head of the torso, see picture 2.1 and fold up the neck see picture 2.2.
Press the head into the connector of the neck until you can hear a "click" sound. (2.3)
4.2. Mounting the head bag and face piece (see picture ③)
Unfold the bag and hold as shown, see picture 3.1.
Holding the neck of the bag, fold together as shown on the photos, see picture 3.2 and 3.3.
Insert bag in the head, see picture 3.4.
Smooth out the edges along the opening in the skull, see picture 3.5.
Hold the face piece by the ears and position on the skull so that the top is flush with the
hairline, see picture 3.6.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido