Removal & Installation Of The Blade; Using Carbide-Tipped Blades - Skil 3820 Instrucciones De Funcionamiento

SM 2610005400 10-09:SM 2610005400 10-09.qxp 12/2/09 7:55 AM Page 34
Removal and Installation
W RNING
repair to avoid possible injury.
Note: Clean blade of any excess oil before installation.
1. Rotate the lower guard 1 by hand. Loosen, but do not
remove, the cover plate screw 2 using a Phillips or
straight screwdriver (Figure 2).
2. Rotate the cover plate 3 counterclockwise so the blade
bolt 4 is exposed (Figure 2).
3. Press and hold the arbor lock. Use the large hex wrench
to remove the blade bolt 4 by turning wrench clockwise.
NOTE: The blade screw has a left hand thread.
4. Remove the blade bolt 4, outer washer 5 and the blade 6.
Inner washer 7 does not need to be removed (Figure 3).
5. To install the 12
deflectors 8 and onto the inner washer shoulder 9 (Figure
3 & 4). NOTE: Make sure the rotation arrow on the blade
matches the clockwise rotation arrow on the lower guard.
W RNING
6. Replace the outer washer 5 in the proper orientation,
and tighten blade bolt 4 finger tight. Press the arbor lock
and tighten blade bolt 4 securely, but do not overtighten.
7. Rotate cover plate 3 clockwise to original position.
Tighten the screw 2.
W RNING
function properly.
8. Be sure the arbor lock is released so the blade turns
freely.
W RNING
contact with the base or turn table structure. If blade contacts
table, seek authorized service.

Using Carbide-Tipped Blades

Handle carbide-tipped blades carefully. Carbide is very brittle
and can be easily damaged. Use caution when you install,
use or store the blades. Do not use a carbide-tipped blade
that is bent or has bent teeth, or if the blade has cracks, is
broken, or has missing/loose carbide tips. Do not operate a
carbide-tipped blade faster than its recommended speed.
Read, understand and follow all warnings and instructions
provided with your carbide-tipped blades.
Assembly
of the Blade
Disconnect plug from power source before
performing any assembly, adjustment or
blade, fit blade between the chip
"
To avoid injury, do not use a blade larger
or smaller than 12 diameter and 1
"
Never use saw without cover plate
securely in place. Lower guard will not
After installing a new blade, lower the
blade into the table slot and check for any
FIG. 2
1
FIG. 3
arbor.
"
4
FIG. 4
34
3
6
8
7
5
6
9
9
8
2
4
5