Rowenta IS6300 Manual De Instrucciones página 18

4. Put the screw back and screw in as far as it will go so that the hanger is firmly fixed to the
pole (fig. 9).
5. Install the steam head between the hanger hooks.
IMPORTANT: Your product is designed to operate using untreated tap water. If your
water is very hard (check with your local water authority) it is possible to mix untreated
tap water with store-bought distilled water in the following proportions 50% untreated
tap water with 50% distilled water. Heat concentrates the elements contained in water
during evaporation. The types of water listed below may contain organic waste, mineral
or chemical elements that can cause spitting, brown staining or premature wear of the
appliance: water from clothes dryers, scented or softened water, water from refrigerators,
batteries, air conditioners, rain water, boiled, filtered or bottled water. These types of water
should not be used. Only use store bought distilled water as advised above.
by pulling the handle upwards (fig. 10). Unscrew the tank cap and fill the tank (fig. 11).
Maximum capacity is indicated by the "max" mark.
leaking through the cap.
USE
WARNING: Never steam a garment while it is being worn.
The flexible pipe and the end of the steam head can become extremely hot during
use. This is perfectly normal. Be careful and avoid any prolonged contact.
of the steamer, ensure the floor is dry, flat, stable and heat-resistant. Do not obstruct the
openings on the lower part of the appliance. This device should not be used on very thick
carpets or rugs.
will come on (fig.14).
To use the Roll & Press system:
from the hook located on the hanger rod (fig. 18-19).
the illustration (fig. 20).
13