Warning Indications; User Information; Important Notes; Safety Instructions - Sicam SBM 55 NW Manual Original

en 32 | SBM 55 NW | User information
1.2.2

Warning indications

DANGER – Exposure of live parts on ope-
ning the SBM 55 NW!
Risk of (fatal) injury or heart failure from elec-
tric shocks on contact with live components
(e.g. master switch, printed circuit boards).
¶
Work on electrical installations or equip-
ment is only to be performed by qualified
electricians or trained personnel under the
guidance and supervision of an electrician.
¶
Disconnect the SBM 55 NW from the mains
before opening.
2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Sicam
Tire Equipment". These instructions must be carefully
studied prior to start-up, connection and operation of
the SBM 55 NW and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety instruc-
tions for Sicam Tire Equipment". These instructions must
be carefully studied prior to start-up, connection and op-
eration of the SBM 55 NW and must always be heeded.
2.3

Electromagnetic compatibility (EMC)

The SBM 55 NW satisfies the requirements of the EMC
directive 2004/108/EG.
i
The SBM 55 NW is a class/category B product as
defined by EN 61 326. The SBM 55 NW may cause
high-frequency household interference (radio inter-
ference) so that interference suppression may be
necessary. In such cases the user may be required to
take the appropriate action.
|
1 695 656 076 2012-03-28
3.

Product description

3.1

Intended use

The SBM 55 NW is a wheel balancing machine with
mechanical attachment for the balancing of passenger
vehicle and motorcycle wheels with a rim diameter of
10" – 24" and a rim width of 1" – 20"*.
The SBM 55 NW is to be used exclusively for this pur-
pose and solely for the range of applications specified
in these instructions. Any other purpose is not consist-
ent with the intended use and is therefore not permis-
sible.
i
The manufacturer cannot accept any liability for pos-
sible damage arising from improper use.
!
* These measurements refer to standard rims (A); for
particularly shaped rims (B - C) it is recommended
using specific accessories.
A
B
C
3.2

Prerequisites

The SBM 55 NW must be installed on a flat surface
made of concrete or similar material and anchored in
position.
!
An uneven or vibrating surface can lead to inaccurate
unbalance measurements.
!
Any uneven floors or that do not meet the previously
expressed safety requisites relieve the manufactu-
rer from any liability for damages to persons and/or
property.
Sicam srl società unipersonale