Rational Combi-Duo Gas Manual Del Usuario página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
5 | Installation
a
The bottom unit is placed on a stand
with feet or castors or an auto levelling
kit.
a
The top side of the bottom unit is
clean and free of grease.
1. Loosen 3 screws from the lid of the
bottom unit [
2. Place the Combi-Duo base plate on
the lower unit. Align the base plate so
that the closed, right side panel is flush
with the right unit wall.
3. Secure the Combi-Duo base plate with
3 screws [
Photo
4. Install the feet on the base plate with
cap nuts [
Photo
5. Place the cover for the flue pipes on
the bottom unit [
6. Install the bracket on the bottom side
of the top base plate [
7. Attach the top base plate to the feet
[
Photo
07].
8. Remove the rubber seal around the
unit feet edges of the top unit
[
Photo
08].
9. Place the top unit on the Combi-Duo
Intermediate Assembly Kit with the
help of carrying straps [
10. Secure the top unit base plate of the
Combi-Duo Intermediate Assembly
Kit with at least 3 screws
[
Photo
10].
11. Install the rubber seal around the bot-
tom edge of the top unit
[
Photo
11].
12. If an Ethernet cable is to be connected
to the top unit, connect the cable be-
fore assembling the exhaust and vent-
ilation pipes for better accessibility.
80.51.374_iCombi Pro-iCombi Classic_CD G_IM_V02_Eur-west
Photo
02].
03].
04].
Photo
05].
Photo
06].
Photo
09].
13. Attach the cover for the flue pipes with
cap nuts and washers.
14. Mount the exhaust and ventilation
pipes [
Photo
15. Mount the exhaust gas stack and at-
tach this with a cap nut and washer
[
Photo
13].
16. Mount the shaft cover on the exhaust
gas stack [
Photo
Turn the door handle of the bottom unit
1. Disassemble the door handle of the
bottom unit: Remove the plastic cover
of the door lock on the inner side of
the door, by sliding the cover towards
the inner side of the door and taking it
out [
Photo
15].
2. Loosen the screws of the door handle
with a 5 mm Allen key [
3. Pull the door handle off, turn it 180
degrees and reattach the door handle
[
Photo
17].
4. Apply the plastic cover [
12].
14].
Photo
16].
Photo
18].
13 / 80
en

Publicidad

Tabla de contenido
loading

Tabla de contenido