Residual Risks; Technical Data; Characteristics Of The Machine; Use Limitation - Apach ASM32F 2S 3PH Instrucciones Originales

RESIDUAL RISKS

Loading, unloading and movement
of the machine
Wrong machine installation
Closure panels, chambre in which
voltage is present
Work without guards
Cleaning the parts in contact with
the mixture

TECHNICAL DATA

CHARACTERISTICS OF THE MACHINE

The electric spiral mixer, produced in versions "5", "10", "15", "20", "30", "40", "50", "60" was designed
to blend both soft and hard mixtures (mix and/or knead), made of flour, salt, yeast, fats and liquids
(water, oil, ...) exclusively for foodstuff use.
Every mixer is composed of:
 a steel structure protected by a heat resistant varnish;
 the bowl, the spiral, the central dough-breaker and the protection grate are all in stainless steel ;
the bowl and the spiral they both rotate clockwise
 chain drive with oil bath gear motor;
 the moving parts are on ball bearing;
 4 castors , 2 of these with brake, in nylon;
 operation with single-phase or three-phase motor, one speed; on request: three-phase motor with
2 speeds;
 Electric circuit fed by a cable to the network to which are connected at low tension (24V) the
control devices to start, to stop, and of the safety devices. Among these internal blocking of the
moving parts activated by the movement of the mobile protection of the pan
The machine, designed in compliance with European Directives, is built to safeguard the user from risks
relating to its use. For this reason, the machine is equipped with specific guards that must not be
tampered with for any reason, in order to avoid risks due to contact with moving parts.

USE LIMITATION

PRODUCTION CAPACITY
kg/h
The data refer to a normal
mix of ten/twelve minutes
17
- Machine falls
- Packaging falls
- Electrical discharges
- Lightening strike
- Electrocution
- Electrocution
- Catching
- Crushing
- Abrasion
- Electrocution
- Electrical discharges
5 10 15
29 35 48
- Handle the machine carefully, packaged or not.
- The mains voltage and frequency as outlined on
the machine plate.
- The power socie must be connected to the
earthing.
- The electricity supply line of the machine,
upstream of the socket must be equipped with
protection using a differential switch, coordinated
with the main earthing system.
- Do not open the panels without disconnecting the
plug in advance.
- Do not remove the guards during machine use.
- The machine must always be cleaned when it is
off, without mains power (cut mains voltage, i.e.
disconnect the plug).
20 30 40
56 88 112
50 60
128 144