FUNAI PB750FX1 El Manual Del Propietario página 58

d) After you enter all correctly, press [OK].
• Confirmation message will appear.
Select "Yes" to complete the settings.
2
Press [RETURN] to go back to the
previous screen, or press [SETUP] to
exit.
Note
• The range of input numbers is between
0 and 255.
• If you enter a number larger than 255,
the number will automatically be 255.
• The manually entered addresses will be
saved even if you change the setting to
"Auto(DHCP)".
• When you enter a wrong number, press
[CLEAR] to cancel. (The number will be
back to "0".)
• If you want to enter 1 or 2 digit number
in one cell, press [B] to move on to the
next cell.
• If the entered IP address or the default
gateway or primary DNS addresses are
the same as the default setting, IP
address setting will be set to
"Auto(DHCP)". (The manually entered
number will be saved.)
• When IP address setting is set to
"Manual", the setting of DNS setting will
automatically be "Manual" and when IP
address setting is set to "Auto(DHCP)",
you can set either "Auto(DHCP)" or
"Manual" for DNS setting.
Proxy Setting
1
Press [OK] repeatedly to select the
desired setting.
• For default settings, select "Do Not Use".
• If you need to change the proxy setting
as instructed by your Internet service
provider to set the designated proxy
address and port, select "Use".
If you select "Use", follow the
instructions below to set the proxy
address and proxy port.
a) Use [K / L] to select "Proxy Address",
then press [OK]. Proxy address setting
screen will appear. Enter proxy address.
EN
[K / L /s / B] : Move the highlight.
[the Number : Enter number.
buttons]
[OK] : Enter the highlighted
[CLEAR] : Clear the entered
b) After you enter proxy address correctly,
press [YELLOW].
• Confirmation message will appear.
Select "Yes" to complete the settings.
c) Use [K / L] to select "Proxy Port" , then
press [OK]. Proxy port setting screen
will appear. Enter proxy port number
with number buttons.
d) After you enter proxy port correctly,
press [OK].
2
Press [RETURN] to go back to the
previous screen, or press [SETUP] to
exit.
Note
• The range of input numbers for the port
number is between 0 and 65535. (If you
enter a number larger than 65535, it
will be regarded as 65535.)
• For proxy port, certain ports might be
closed, blocked or unusable depending
on your network environment.
Connection Speed
You can set connection speed as your
preference. (The default setting is "Auto".)
1
Press [OK] to show the options for
"Connection Speed".
2
Use [K / L] to select the desired
setting, then press [OK].
"Auto":
Set the appropriate connection speed
automatically, in accordance with your
network environment.
"10BASE Half":
Set the connection speed to "10BASE
Half".
"10BASE Full":
Set the connection speed to "10BASE Full".
"100BASE Half":
Set the connection speed to "100BASE
Half".
(continue on next page)
item.
number or word.
53