Maintenance - FUNAI PB750FX1 El Manual Del Propietario

Maintenance

Servicing
• Please refer to relevant topics on "Troubleshooting" on
page 59 before returning the product.
• If this unit becomes inoperative, do not try to correct
the problem by yourself. There are no user-serviceable
parts inside. Turn the unit to the standby mode,
disconnect the AC adapter and detach the battery
pack, and please contact
1-877-39-Funai (1-877-393-8624)
or visit : www.funaiamerica.com
Cleaning the cabinet
• Wipe the main unit with a soft cloth.
• Disconnect the AC adapter and detach the battery
pack when cleaning the unit.
• Never use a solvent, thinner, benzene or alcohol to clean
the unit. Do not spray insecticide liquid near the unit. Such
chemicals may discolor the surface or damage the unit.
• Rubbing or wiping the LCD screen and around the LCD
screen with hard cloth may scratch the surface.
Cleaning discs
• When a disc becomes dirty, clean it with a cleaning
cloth. Wipe the disc from the center to the outer edge.
Do not wipe in a circular motion.
• Do not use solvents such as benzine, thinner, commercially
available cleaners, detergent, abrasive cleaning agents or
antistatic spray intended for analog records.
Cleaning the disc lens
• If this unit still does not perform properly although you
refer to the relevant sections and to "Troubleshooting" in
this manual, the laser optical pickup unit may be dirty.
Consult your dealer or an authorized service center for
inspection and cleaning of the laser optical pickup unit.
Disc handling
• Handle the discs so that fingerprints and dust do not
adhere to the surfaces of the discs.
• Always store the disc in its protective case when it is
not used.
• Note that discs with special shapes (heart-shaped discs,
octagonal discs, etc.) cannot be played back on this
unit. Do not attempt to playback such discs, as they
may damage the unit.
IR signal check
• If the remote control is not working properly, you can use a
digital camera (including a cellular phone with built-in
camera) to see if it is sending out an infrared signal.
With a digital camera
(including built-in cell phone cameras):
Point a digital camera towards the remote
control. Push any button on the remote
control and look through the digital camera.
If the infrared light appears through the
camera, the remote control is working.
4 EN