FUNAI PB750FX1 El Manual Del Propietario página 60

"WPA2-PSK (AES)":
Set the authentication setting to "WPA2-
PSK (AES)".
7
"WEP/ WPA Key" entry screen will
appear. Enter the WEP/WPA key of
the selected wireless network using
cursor buttons, number buttons
and color key, then press [YELLOW].
• Confirmation message will appear.
Select "Yes" to complete the settings.
8
Following screen will appear. Use
[K/L] to select "Yes", then press
[OK] to go to "Advanced Settings".
• For further operation, refer to
"Advanced Settings" on this page.
9
Press [SETUP] to exit.
Note
• For a wireless network with
authentication setting, key icon appears
to the right hand of the wireless
network name (SSID).
• Signal icon shows the strength of the
signal.
• WEP/WPA key appears as asterisks on
the confirmation screen.
• The supplied USB wireless LAN adapter
supports following specifications.
- Wireless
standards
- Frequency
spectrum
- Security
protocol
Manually enter your SSID
Set up the connection to the wireless router
manually by entering the wireless network
name (SSID).
1
Follow steps 1 to 3 in "Find wireless
network" on pages 54-55.
2
Use [K / L] to select "Manually
enter your SSID", then press [OK].
• Wireless Router Name (SSID) entry
screen will appear. Enter the wireless
network name (SSID) using cursor
buttons, number buttons and color key,
then press [YELLOW].
• List of authentication settings will
appear.
EN
: IEEE 802.11 b/g/n
: 2.4GHz
: WEP / WPA / WPA2
3
Follow steps 6 to 9 in "Find wireless
network" on pages 54-55.
Wireless Router Status
You can check the current status of "Wireless
Router" setting.
1
Follow steps 1 to 3 in "Find wireless
network" on pages 54-55.
2
Use [K / L] to select "Wireless
Router Status", then press [OK].
• The list of current wireless router
settings, and the confirmation message
will appear. Select "Yes" to complete the
settings.
3
Press [RETURN] to go back to the
previous screen, or press [SETUP] to
exit.
Advanced Settings
After you set up the "Wireless Router" setting,
set the network setting to "Easy" (wireless) or
"Custom"(wireless).
Easy (wireless)
To set the network setting to "Easy"(wireless),
follow the procedure below. For details of
this setting, refer to "Easy (Wired)" on page 52.
• If you select "Yes" in step 7 of "Find wireless
network" on pages 54-55, skip to step 3.
1
Follow steps 1 to 2 in "Find wireless
network" on pages 54-55.
2
Use [K / L] to select "Advanced
Settings", then press [OK].
3
Use [K / L] to select "Easy", then
press [OK].
Custom (wireless)
To set the network setting to
"Custom"(wireless), follow the procedure
below.
• If you selected "Yes" in step 7 of "Find
wireless network" on pages 54-55, skip to
step 3.
1
Follow steps 1 to 2 in "Find wireless
network" on pages 54-55.
2
Use [K / L] to select "Advanced
Settings", then press [OK].
(continue on next page)
55