Storing The Receiver In The Mouse - Microsoft 1023 Manual Del Usuario

Connect the Receiver to the Computer
3
With Universal Serial Bus (USB) simplicity, you can
connect the receiver in one simple step.
To connect the receiver
• With your computer turned on, plug the rectangular
USB connector into your computer's USB port.
Test the Mouse
4
Try using the mouse. If it does not work as expected, make sure that you
completed the following procedures as specified earlier in these instructions:
• Each battery is new and inserted correctly.
• The receiver is properly connected to the computer.
• The receiver and mouse are properly positioned within their wireless range.
If the mouse is still not working, try reconnecting the mouse to the receiver.
To reconnect the mouse to the receiver
1 Make sure that the mouse and receiver are positioned as specified earlier in
these instructions.
2 Press the button on the wireless receiver, and then immediately press the
button on the bottom of the mouse. Using the tip of a pen may make it easier to
press smaller buttons.

Storing the Receiver in the Mouse

For added portability or when the mouse is not in use, you can snap the receiver
into its slot on the bottom of the mouse. Attaching the receiver to the mouse in this
way automatically turns the mouse off.
4
X1039839mnl_enu.indd 4 4/22/04, 6:45 PM