Instructions For Using The Motorcycle; Starting The Engine - SWM VA'RE:Z125 Guía Rápida

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

INSTRUCTIONS FOR USING THE MOTORCYCLE

STARTING THE ENGINE

After getting on the motorcycle as described in the
relative paragraph, operate as follows to start the
engine:
place key (1) of the ignition switch to
-
buzz that you hear when you turn the key to this
position is caused by the fuel pump which puts the
feeding system under pressure. If you do not hear
the buzz, make sure that the button (4) is properly
positioned;
pull the clutch lever (2);
-
shift gear pedal (3) to neutral position then release
-
the clutch control level;
check that the button (4) is in
-
press the start button (5). When a cold engine has
just been started, do not increase revs, to ensure an
adequate oil warm-up and circulation in all points
that require lubrication.
WARNING
Do not run the engine cold at high revs.
Note
A safety switch is fitted on the clutch lever support.
position. The
This switch allows you to start the engine only
with gearbox in neutral position, or with the gear
engaged and the clutch lever pulled.
With the stand lowered, the bike can only be started
with the gear in neutral.
position and then
11
EN -

Publicidad

Tabla de contenido
loading

Tabla de contenido