Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
Electrical Connection
Cable
3.1
Intialisation
Startup sequence after power has been connected to the sensor:
-Both green & red LED's begin to blink slowly
-Green LED will continue to blink quickly
4
Introduction to the RegloBeam 2 Remote Control
The RegloBeam 2 remote control allows Herkules 2E to be easily and
conveniently programmed from the ground. Data transfer between the
RegloBeam 2 and Herkules 2E functions in both directions, i.e. to and from
the sensor by an infrared interface. The RegloBeam 2 reads back the ad-
justed values immediately after programming and displays them on the
remote to ensure accurate programming.
4.1
Layout of the RegloBeam 2 Remote Control
A
B
C
A Transmitter/receiver (infrared)
B Status indicator LED
C Numerical buttons (1 to 9)
D Function buttons (A to F)
E Start button:
a) Powers on (hold 2 sec)
b) Establishes connection to the sensor
F Remote function quick reference guide
(stored in slot on battery compartment cover)
This guide is included in every Herkules 2E box
10 - 36 VDC/
Brown
12 - 28 VAC
Green
Yellow
Grey
Pink
F
Herkules 2E
350841A 12/15
Function
Remote
Values/
Description
Function
2.0 – 2.5 m
2.5 – 3.0 m
Mounting
3.0 – 4.0 m
A
Height
4.0 – 5.0 m *
5.0 – 6.0 m
6.0 – 7.0 m
Output
Vehicles forward*
Configu-
Vehicles backward
ration
Vehicles both dir
People forward**
Output #1
People backward
(Green LED)
B
People both dir
Output #2
People/vehicles fwd
C
(Red LED)
People/veh bkwd
People/veh both dir
Field size/
X-small/least sens.
Sensitivity
Small/less sens.
Medium/norm sens.
Output #1
D
Large/very sens.*
Output #2
E
Xlarge/most sens.
Output
0.2 sec
Hold Time
0.5 sec
1.0 sec
2.0 sec*
F 1
Output #1
5.0 sec
D
Pulse on exit
Output #2
F 2
Output steadily on
Output steadily off**
* Factory Settings
** Factory Settings for output 2
E
Power
See table on pages 5 & 6 for detailed information
Output 1
COM
on output 1
(Green LED)
NO (NC)
*Factory setting = Output 2 off
Output 2*
COM
(Red LED)
NO (NC)
See table on pages 5 & 6 for detailed information
on output 2
Flashing buttons on the RegloBeam 2 indicate that the data has
not been fully transmitted.
Avoid exposing the infrared interface to direct sunlight or other light sour-
ces.
4.2
Turning on the RegloBeam 2 Remote Control
The RegloBeam 2 must be powered on before use.
i
POWER ON: Press and hold G for 2 seconds
POWER OFF*: Press and hold G for 2 seconds
* The remote will automatically turn off after 2 minutes if no
button is pressed.
3
Publicidad
Tabla de contenido
