Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador página 52

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 135
CONTACT
14(FT2)
13(COM)
15(FT1)
13(COM)
16(COS2)
13(COM)
17(COS1)
13(COM)
18(ST)
13(COM)
19(PP)
13(COM)
20
21(ANT)
22(ORO)
26(COM)
23(PED)
26(COM)
24(CH)
26(COM)
25(AP)
26(COM)
SB
FC
ENC
52
DESCRIPTION
Input (N.C.) for connecting photocells FT2
The photocells FT2
resumed opening when the photocell is cleared.
. Movement is reversed if the photocell FT2 is triggered during gate closure.
.
and
.
Input (N.C.) for connecting photocells FT1
The photocells FT1
. Photocell triggers only during gate closure. Photocell is ignored during gate opening.
. Movement is reversed if the photocell FT1 is triggered during gate closure.
.
and
.
Input (NC or 8 kOhm) for connecting sensing edge COS2
. The sensing edge COS2 (NC contact) is disabled.
.
Input (NC or 8 kOhm) for connecting sensing edge COS1
. The sensing edge COS1 (NC contact) is disabled.
.
STOP command input (NC). The current manoeuvre is arrested if the safety contact opens. N.B.: the
controller is supplied with this contact already jumpered by ROGER TECHNOLOGY.
Step by step mode command input (N.O.).
The function of the control is determined by parameter
Antenna connector for slot-in radio receiver board.
N.B.
Clock timer contact input (N.O.).
Partial open control signal input (N.O.).
Set by default to 30% of completely open position.
Close command input (N.O.).
Open control signal input (N.O.).
stops and no command signals are accepted.
initiates the position recovery procedure (see chapter 18).
N.B.
Connector (N.C. contacts) for connecting mechanical limit switch (see
netic limit switch (see
N.B.
Connector for connecting to encoder installed on motor.
WARNING! Always disconnect from electrical power before disconnecting or connecting the
encoder cable.
N.B.
the gate stops as long as the photocell is obstructed. The gate
14(FT2) - 13(COM) or set the parameters
15(FT1) - 13(COM) or set the parameters
16(COS2) - 13(COM) or set the parameter
17(COS1) - 13(COM) or set the parameter
.
- detail B). The gate stops when the limit switch is activated.
.
- detail A) or mag-

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H70/105ac

Tabla de contenido