Adjusting Seat-To-Floor Height - Sunrise Medical Breezy Manual De Instrucciones

24

ADJUSTING SEAT-TO-FLOOR HEIGHT

(FIGURE 22)
After ANY adjustment, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely – otherwise injury or damage may result.
CAUTION- When changing the seat-to-floor height, the height of the anti-tippers must as
well adjusted.
1. Remove rear wheel. Refer to Wheelchair Basics Section 3 of this manual
2. Remove front caster journal (housing) if the adjustment requires a six in. front caster.
Only remove the front caster tire if its adjustment requires moving the existing wheel
up or down in the caster fork. Refer to Caster section for removing and adjusting
caster tires of this manual
3. Refer to the chart outlining front caster/fork and rear wheel sizes, to determine
mounting positions for obtainable seat-to-floor height.
4. Reinstall the front caster or front caster tire onto the wheelchair. Refer to caster sec-
tion for installing caster fork and/or caster tires earlier in this manual
5. Reinstall the rear wheels onto the wheelchair. Refer to Wheelchair Basics Section 3 of
this manual.
6. Adjust Anti-Tippers according to NEW seat-to-floor height. Refer to Anti-Tippers sec-
tion of this manual for proper adjustment.
CAUTION- It is important that the leading edge of the caster journal is perpendicular to
the ground.
SEAT-TO-FLOOR HEIGHT MATRIX
Front Frame
Seat To Floor
Height
13 1/2" HEMI
14 1/2" HEMI
15 1/2" STANDARD
16 1/2" STANDARD
16 1/2" STANDARD
17 1/2" STANDARD
17 1/2" STANDARD
18 1/2" STANDARD
17 1/2" STANDARD
18 1/2" STANDARD
19 1/2" STANDARD
930853 Rev. B
E n g l i s h
WARNING
Rear Wheel Rear
Size Axle
Position
20" TOP
20" BOTTOM
20" TOP
20" BOTTOM
22" TOP
22" MIDDLE
22" TOP
22" MIDDLE
24" TOP
24" MIDDLE
24" BOTTOM
I X . S e t - U p , A d j u s t m e n t & U s e
Front Front
Caster Caster Axle
Position
6" TOP
6" BOTTOM
6" TOP
6" BOTTOM
6" TOP
6" BOTTOM
8" TOP
8" MIDDLE
8" TOP
8" MIDDLE
8" BOTTOM
22
TOP
MIDDLE
BOTTOM