Hach AS950 Manual Del Usuario página 21

5.3 Start or stop the program
Start the sampling program to collect samples. Temporarily stop the sampling program to remove
samples, do manual operation or do a calibration. Stop the sampling program to change the
sampling program, the data log settings or the channel alarms.
Note: When data logging is configured, data logging is done even when the sampling program is temporarily
stopped.
1. Push RUN/HALT.
2. Select an option.
Option
Start Program
Halt Program
Resume
Start From Beginning Starts the sampling program from the beginning.
End Program
5.4 Show data and alarms
5.4.1 Show the program status
1. Push STATUS or select Diagnostics>Status from the main menu.
2. If two sampling programs are in operation, select one of the sampling programs. The status of the
sampling program shows. In addition, the sample status, data log status, alarm status and
hardware status shows.
Status
Program Running
Description
Starts the sampling program.
Note: The sampling program may not start immediately. Refer to
the sampling program starts
Stops the sampling program temporarily. The status changes to
Program Halted.
Starts the sampling program from the point at which it was stopped.
Stops the sampling program. The status changes to Program
Complete.
Description
The sampling program is in operation.
on page 16.
Select when
English 21