Assembling The Stand - skilsaw SPTA70WT-ST Instrucciones De Funcionamiento

SM 2610042781 12-15.qxp_BM 2610016588 02-11.qxp 1/4/16 7:52 AM Page 3

Assembling the Stand

1. Slide the legs into the stand (Fig. 1).
Note: Each leg is marked A, B, C, or D.
These correspond with the respective leg on
the main stand. Match A with A and B with
B, etc.
2. Align the holes in the leg with the holes in
the stand.
3. Install two bolts through each leg.
4. Using a wrench and a phillips
screwdriver, tighten the nuts securely.
1. Unfold stand to open position and flip over
clip on each side of table, as depicted in
figure 2.
2. Place table saw onto the stand so that the
feet rest in the indentations on the stand
(Fig. 2). Make sure the saw base lines up
evenly with the edge of the stand.
3. Once base is aligned, hook the clamps on
both the front and back over the base of the
saw and lock in place (Fig. 3).
Note: To remove the saw from the stand,
follow the same procedure in reverse.
Bolt
Leg
Mounting Saw to Stand
FIG. 2
FIG. 3
-3-
Clips
Lock Nut
Adjustable
Foot
FIG. 1