Installation Steps; Care And Cleaning - AVS Bugflector Instrucciones De Instalación

Installation Steps

Center part on front edge of hood and align holes.
3
Remove remaining tape liner by pulling on exposed
ends. Apply pressure to outboard flanges to ensure
tape adhesion.
5
Close Hood.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2007 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo, Chromeflector
TM TM
Install (2) fasteners in the INBOARD holes.
4
Install (2) self tapping screws through the
OUTBOARD holes on hood shield.
6
Apply bump ons to surface of hood.
8
, and the AVS logo are trademarks of Lund International, Inc.
TM TM
Page 2 of 2
outboard
inboard
NOTE: Do not over tighten
hood
hood shield
washer
screw