Publicidad
PRELIMINARY REV. 06
Installation manual
POSITIONING THE PARTS OF THE SYSTEM
Siren
This must be positioned in the engine
compartment as far as from heat sources. Refer
to the drawings for the unit fastening on the
bracket and its orientation.
We recommand to fix the unit in a hidden
position, difficult to be reached.
ELECTRICAL CONNECTIONS
Remember to position the alarm wires so that they are routed along with the original harness
of the vehicle and to attach them to this with the relative clamps.
Refer to the enclosed wiring diagrams when making the electrical connections, bearing the
following instructions in mind:
• the ground must be shunted from an original ground point of the vehicle or connected
straight to the negative pole of the battery.
• the positive wire of the alarm unit must not be connected to a positive protected by an
original fuse.
In fact, the alarm unit is already equipped with internal solid state electronic
fuses that protect it in case of short circuits. In this case it will be enough to
restoring the system to the standard operation.
12
GB
06DE1429C ok.p65
12-13
All manuals and user guides at all-guides.com
30°
PRELIMINARY REV. 06
AUTO-LEARNING PROCEDURE FOR EMERGENCY ELECTRONIC KEYS
In emergency case, the electronic keys will replace the original radio control.
To couple the above keys to the system:
1. Disarm the system.
2. Prepare all the electronic keys that you wish to couple.
3. Turn the ignition key on then off for 3 times within 7 seconds.
4. The transmitter LED will go on for 3 seconds signalling that you can insert the personal
code (PIN).
5. After the LED will go off, turn the ignition on and count the LED blinks up to the number
which is the first digit of your PIN-CODE (for example: 2 BLINKS = 2 is the first digit) then
switch the ignition off.
Repeat the same procedure for all the digits.
In case of any mistake just wait for 10 seconds leaving the ignition key off without making
any operation and then come back to step 3.
6. Turn the ignition key on. The LED will come on a fixed way signalling that the personal PIN-
CODE is correct.
7. Insert the electronic key in the emergency panel for one second; the LED goes off then on
signalling the coupling of the electronic key to the system.
8. Repeat the operation described in step 7 for all the electronic keys you want to add.
9. The auto-learning procedure can be interrupted at any moment by simply turning the ignition
key off.
Note: as soon as a new electronic key is coupled, the system will automatically decoupling those
previously used. If you want to keep them working, you must couple them again.
The system can work with 4 electronic keys maximum.
The coupling of 2 or more electronic keys will deactivate the PIN-CODE as an emergency
system ( the code will be helpful only in the case of programming of new keys).
9-05-2001, 11:05
Installation manual
13
GB
Publicidad
