Install The Ups; Rack-Mount Installation; Tower Installation - INFOSEC UPS SYSTEM E6 LCD RT Evolution TX 5 KVA Guia Del Usuario

2.2 Install the UPS

Rack-mount installation


Step 1: Attach mounting ears to the side
mounting holes of UPS using the screws provided
and the ears should face forward.

Tower installation

The UPS system is shipped with four plastic feet and 6 plastic extensions (2 short extension plus 4 long extensions). Those
can be used to tower install the UPS power module in 3U or UPS power module with one battery bank in 6U or UPS module
with ISO bank and one battery bank (9U).
To install in 3U, it's not necessary to use long extensions.

Assemble two feet and
one short extension
together as one supporter
with 13cm width available.
Another supporter could
be assembled in same
method
8
All manuals and user guides at all-guides.com
Step 1
Step 1 Step 2

Align the two stands
approximately 35cm apart in
step 2.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 05 13 AA 59 206 14
Step 2

Step 2: Lift the UPS module and slide it into
rack enclosure. Attach the UPS module to
the rack with screws, nuts and washers
(user-provided) through its mounting ears
and into the rack rails.
Step 3

Then, put UPS module in the
stands as shown in step 3.
Be sure that the LCD of UPS
should be on upper half part
of front panel.