EdilKamin BERING Manual Del Usuario página 35

COMPONENTS - SAFETY AND DETECTION DEVICES
on the smoke outlet. It reads the smoke temperature. It regula-
temperature is too high or too low (SF o AL 07).
Flow sensor
cause the consequent risk of problems of depression in the
fumes circuit).
Mechanical pressure switch
Feed Screw safety thermostat
Placed near the pellet hopper. It disconnects the electrical sup-
ply to the gear motor if the temperature detected is too high.
Water temperature detector
It reads the water temperature in the boiler and sends the circuit
board information for pump management and boiler power
modulation.
Water overheating safety thermostat
detects the water temperature in the thermo-stoves. If this is
electrical supply to the gear motor.
If the thermostat has been tripped it must be reset using the re-
set button behind the boiler after having removed the protective
cap.
Overpressure valve 3 bar
is triggered to discharge the water and consequently the water
must be topped up.
sewage system.
Resistance
It sets off of the combustion of the pellets and it remains lit until
via a vacuum.
Gear motor
red from the hopper to the combustion chamber.
Vacuum gauge (electronic pressure sensor):
value (compared to the installation environment) in the combu-
stion chamber.
N.B.:
IF THE BOILER BLOCKS, THE REASON WILL APPEAR ON THE DISPLAY AND THIS WILL BE SAVED.
FEATURES
Located on the system that loads the pellets from the hopper.
Pump (circulator)
de the
Aheating technician must evaluate the need to add a second
ter in the system.
Manometer
It is positioned on the inside of the front part of the boiler
(opening the door) and shows the pressure of the water in the
boiler.
The recommended pressure is 1.5 bar when the boiler is on.
Drain tap
the water inside the boiler must be emptied.
Manual relief valve
ding of water inside the boiler.
-
- 35
-
due to the heating effect.
V2
V1
-
-
-