Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Boiler output setting
To reset the temperature of the boiler OUTPUT water, proceed
as follows: from the HOME screen, press any key and then the
with the enter key
.:
C O N S O L E
B O I L E R
C A L D A I A
ESC
Go to the BOILER STATUS screen, press the key once, go to
the SET BOILER screen, set the SET at the desired value using
the + and - keys, the temperature can be set from a minimum of
50°C to a maximum of 80°C.
S E T B O I L E R = 6 5
S E T
C A L D A I A
6 5 °
ESC
Press the
key to move to the next setting, press the ESC key
repeatedly to return to the HOME screen.
Boiler activation/deactivation
Navigating around the boiler menu with the
BOILER PELLET menu can be found; this setting is used if
otherwise the factory setting must be maintained: ACTIVE
P E L L E T B O I L E R
C A L D A I A
A T T I V A
A C T I V E
ESC
INSTRUCTIONS FOR USE
=
P E L L E T
=
THE ELECTRONIC CIRCULATOR
lator with electronic motor.
Electronic control of operation:
a) Control mode p – c
pressure generated by the pump at a constant set value of H s.
Pressure differential
b) Control mode p – v
differential between the set value Hs and 1/2 H s. The pressure
Pressure differential
c) Venting procedure
This procedure allows the expulsion of air present in the
the pump will automatically alternate between maximum and
the circulator will go to the pre-set speed. You can then select
the desired mode of operation
- 52
-
olume o
olume o
-
Publicidad
Tabla de contenido
