Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10683/2012.
This standard indicates the control operations to be carried out
te the boiler based on the pellet type used and the installation
conditions.
sion the boiler in order for the guarantee to be activated.
The DEALER must also:
- Verify that the hydraulic system is correctly installed and is
guarantee safety.
guarantee appropriate protection from thermal expan-
sion occurring in the whole system.
Therefore the installer must assess whether an additio-
system installed.
- Connect the electrical power to the boiler and implement a
cold test (to be carried out by the DEALER).
Before igniting you must check:
tors temporarily decreases.
NOTE regarding the fuel.
BERING is designed and programmed to burn wood pellets
with 6/8 mm diameter. Pellets are a type of fuel in the form of
under high pressure with no adhesives or foreign materials.
They are sold in bags of 15 kg.
will render the warranty null and void. Such use is detected
by laboratory analyses.
stoves to guarantee the best performance when pellets with
the following characteristics are used:
INSTRUCTIONS FOR USE
-
-
-
- 44
ATTENTION:
operation using the manual valves (V1 - V2) located on the
front part of the top.
and in the event the plant has only been partially reloaded. The
presence of air in the ducts does not allow for proper operation.
Rubber tubes are supplied with valves V1 and V2 to facilitate
relief operations.
V2
- diameter: 6/8 millimetres
- maximum length: 40 mm
- maximum moisture content: 8%
stoves must be recalibrated – a similar procedure to that
malfunctions; stop the boiler-stove from functioning due to
-
V1
Publicidad
Tabla de contenido
