Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
POSSIBLE TROUBLESHOOTING
Actions:
Check:
N.B.:
the ignition cycle begins.
10) Signalling: AL C: H 10 (low current alarm)
Problem:
Boiler shut-down for anomalous absorption
This occurs when the gear motor absorbs less current than normal or when the mechanical safety pressure
switch has been triggered.
Actions:
Check:
11) Signalling: AH C: H 11 (high current alarm)
Problem:
Boiler shut-down for anomalous absorption
This intervenes when the gear motor absorbs more current than normal.
Actions:
Check for any obstructions in the pellet loading channel (loading screw and slide) or for falling objects in the
pellet hopper which block the rotation of the loading screw.
Repeat ignition and observe the fall of the pellets into the chamber; otherwise contact the technical assistance centre.
12) Signalling: "Bat. 1"
Problem:
The boiler does not stop but the error appears on the display.
Actions:
Air vent of at least 80 cm² in the room or direct connection with the outside environment.
Smoke outlet that is at least 80 mm in diameter.
secondary circuits).
NO. Practically all of the heat produced is transferred to the water.
It is advisable in any case to use a radiator in the same room.
4) Can I connect the inlet and outlet of the boiler directly to a radiator?
5) Do boiler also supply hot sanitary water?
It is possible to produce hot sanitary water evaluating the power of the boiler and the water plant.
forms in the installation environment.
7) Do I need an air inlet in the room where it is installed?
(see page 32).
FAQ
- 56
-
-
Publicidad
Tabla de contenido
