Filling The Tank (Fig. D); Detergent Chemical Tank (Fig. E) (If Present); Operation (Fig. A-F); A - Checks Before Use - Ghibli & Wirbel RACER R 85 FD 65 Manual De Uso Y Mantenimiento

10.1 - FILLING THE TANK
(Fig. D)
WARNING:
Only add clean mains water to the
tank at a temperature no greater than
50°C.
- Using the extractable pipe (52) fill water
into the tank (13) until it is replenished.
- Or, if available, open cap (14) and use the
acquastop intake (53, if present).
- At the end of the tank replenishment close
the cap (14).
NOTE:
For machines without the chemical kit, fill the
tank (13) with clean water and mix it with the
chemical detergent.
Always follow the dilution instructions indi-
cated in the label of the chemical product
packaging, to prepare the detergent solution.
10.2 - DETERGENT CHEMICAL
TANK (if present) (Fig. E)
NOTE:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
- Raise the recovery tank (11).
- Check that in the tank (54) there's the
product necessary for the working day.
In case of tank replacement work as indicate
below:
- Remove the cap (55), extract the tank (54)
and insert a new 5 litres one then insert
the cap (55) using the small suction pipe.
DANGER:
In case of contact of the detergent
with the eyes and skin, or in case of
ingestion, please refer to the safety
and application bulletin of the deter-
gent manufacturer.
NOTE:
The tanks (54) to use are the standard 5 li-
tres type which can be found on the market.
- Lower the recovery water tank carefully
(11).
- Carry out the air purge (see the procedure
on item "Chemical agent dosing button").
11 -

11.1 - OPERATION (Fig. A-F)

11.1.a - Checks before use

- Check that the recovery tank's drain-
age tube (15) is properly connected and
sealed.
- Check that the squeegee's water suction-
ing tube (16) is properly inserted into the
recovery tank.
- Check that the coupling (37) on the
squeegee (20) is not obstructed and that
the tube (16) is properly connected.
- Check the charge status of the batteries
by turning the key (29) to its "ON" position
and checking the charge indication on the
display (41).
11.1.b - Preparing the machine and
choosing the cycle
- Sit on the driving position.
- The machine can perform 4 working cy-
cles:
ENGLISH - 12
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968