Fuse Check/Replacement; Alarms During The Functioning (Fig. F) - Ghibli & Wirbel RACER R 85 FD 65 Manual De Uso Y Mantenimiento

15.1 - FUSE CHECK/REPLACEMENT

NOTE:
All machine electrical circuits are protected by auto-resettable electronic devices. The safety
fuses activates only in case of serious damage.
It is recommended to have the fuses replaced by qualified personnel only.
16 -

16.1 - ALARMS DURING THE FUNCTIONING (Fig. F)

When a machine malfunction takes place, the display (41) indicates the type of alarm accord-
ing to the list shown below.
Consult the list and put in place the solution recommended to restore the correct functioning
of the machine.
Should the recommended remedy fail to solve the problem, get in contact with the Technical
Assistance Service.
ALARM
AL_1: General
AL_2: General
AL_3: General
AL_4: General
AL_6: General
AL_7: General
AL_8: General
AL_9: General
AL_10: General
AL_11: General
AL_12: General
AL_13: General
MEANING
Memory error
Key malfunction
Low voltage
Excessive voltage
Absence of communica-
tion with the command
dashboard or display
Ffm communication
Communication
Internal 1 and 2
Insert tag
Invalid tag
Updating in progress...
Turn off
ENGLISH - 20
Professional Cleaning Machines Since 1968
SOLUTION
Restart the machine.
Turn off the machine for at least 10 seconds, then
restart.
Turn off the machine, check the status of the
battery charge, fuses, contacts, cabling and con-
nections, then restart the machine.
Turn off the machine, check the fuses, con-
tacts, cabling and connections, then restart the
machine.
Turn off the machine, check the contacts, cabling
and connections, then restart the machine.
Turn off the machine, check the contacts, cabling
and connections with the communication module
and the functioning of the later, then restart the
machine.
Restart the machine.
Visualisation of missing "Tag" key: insert key.
Visualisation of wrong "Tag" key: change key or
damaged key.
Visualisation of remote parameter updating in
progress: wait for the end of the updating.
Visualisation of parameter updating completed:
restart the machine.
www.ghibliwirbel.com