Accessories; Before Installation - Airwell AW-WHPMA18-H93 Manual De Instalación

3 ACCESSORIES

Accessories supplied with the unit
Name
Installation and owner's
manual(this book)
Operation manual
Technical data manual
Thermistor for domestic hot water
tank (T5) *
Extension wire for T5
Tighten belt for customer wiring use
Accessories avaliable from supplier
Thermistor for balance tank (Tbt1)*
Thermistor for balance tank (Tbt2)**
Thermistor for Zone 2 flow temp. (Tw2)
Thermistor for solar temp. (Tsolar)
*If the system is installed in parallel,Tbt1 must be connected and installed in the balance tank.
**If the volume of the balance tank is relatively large, in order to ensure the use effect, it is recommended to add a Tbt2 sensor
in the lower part of the balance tank.
**When the units are connected in parallel, such as when the communication between the unit is unstable (such as an Hd fault code),
add a network matching wire between the ports H1 and H2 at the terminal of the communication system;
Sensors Tbt1, Tbt2, T5 and extension wire can be shared, sensors Tw2, Tsolar and extension wire can be shared, if these functions
are needed at the same time, please customize these sesors ande extension additionally.

4 BEFORE INSTALLATION

Before installation:
Handling:
Due to relatively large dimensions and heavy weight, the unit should only be handled using lifting tools with
slings. The slings can be fitted into foreseen sleeves at the base frame that are made specifically for this purpose.
To avoid injury, do not touch the air inlet or aluminum fins of the unit.
Do not use the grips in the fan grills to avoid damage.
The unit is top heavy! Prevent the unit from falling due to improper inclination during handling.
The hook and
barycenter of the
unit should be on
a line in vertical
direction to
prevent improper
inclination
Shape Quantity
1
1
1
1
1
2
1
1
1
1
Be sure to confirm the model name and the serial number of the unit.
CAUTION
≥1000mm
Make the rope go
through the lifting
holes from both
the right and left
sides in the
wooden collet
06
Name
Y-shape filter
Water outlet connection pipe
assembly+rubber stopper
Wired controller
Adapter for inlet water pipe
+sealing ring
Network matching wire***
Energy label
Extension wire for Tbt1
Extension wire for Tbt2
Extension wire for Tw2
Extension wire for Tsolar
The position of barycenter for different unit can be seen in the
picture below. (unit:mm)
670
304
Shape Quantity
1
2+2
1
1+1
1
1
1
1
1
1
670
425