Symbol Explanation - SMA SUNNY TRIPOWER CORE1 Instrucciones Breves

SMA Solar Technology AG
Change to the names and units of
grid parameters to comply with the
grid-connection requirements in
accordance with Regulation (EU)
2016/631 (valid from April 27, 2019)
To comply with the EU grid-connection requirements
(valid from April 27, 2019) the names and units of
grid parameters were changed. This change is valid
from firmware version ≥ 3.00.00.R if a country data
set for fulfilling the EU grid-connection requirements
(valid from 2019-04-27) is set. Names and units of
grid parameters for inverters with firmware version
≤ 2.99.99.R are not affected by this change and
remain valid. This also applies from firmware version
≥ 3.00.00.R if a country data set that is valid for
countries outside the EU is set.
3 Symbols on the Product

Symbol Explanation

Beware of a danger zone
This symbol indicates that the product
must be additionally grounded if addi-
tional grounding or equipotential bond-
ing is required at the installation site.
Beware of electrical voltage
The product operates at high voltages.
Beware of hot surface
The product can get hot during opera-
tion.
Observe the documentation
Observe all documentation supplied with
the product.
Inverter
Together with the green LED, this symbol
indicates the operating state of the in-
verter.
Observe the documentation
Together with the red LED, this symbol in-
dicates an error.
Data transmission
Together with the blue LED, this symbol
indicates the status of the network con-
nection.
Grounding conductor
This symbol indicates the position for con-
necting a grounding conductor.
Grounding
This symbol indicates the position for the
connection of an additional grounding
conductor.
Three-phase alternating current with neu-
tral conductor
Quick Reference Guide
Symbol Explanation
Direct current
The product has no galvanic isolation.
WEEE designation
Do not dispose of the product together
with the household waste but in accor-
dance with the disposal regulations for
electronic waste applicable at the instal-
lation site.
The product is suitable for outdoor instal-
lation.
Degree of protection IP65
The product is protected against the pen-
etration of dust and water that is directed
as a jet against the enclosure from all di-
rections.
CE marking
The product complies with the require-
ments of the applicable EU directives.
RoHS labeling
The product complies with the require-
RoHS
ments of the applicable EU directives.
RCM (Regulatory Compliance Mark)
The product complies with the require-
ments of the applicable Australian stan-
dards.
ICASA
The product complies with the require-
ments of the South African standards for
telecommunication.
ANATEL
The product complies with the require-
08492-17-03337
ments of the Brazilian standards for
telecommunication.
Este equipamento opera em caráter se-
cundário, isto é, não tem direito a pro-
teção contra interferência prejudicial,
mesmo de estações do mesmo tipo, e
não pode causar interferência a sistemas
operando em caráter primário.
The product complies with the Moroccan
safety and EMC requirements for elec-
tronic products.
STP50-40-IS-xx-20
3 Symbols on the Product
7