Canon PIXMA MP600R Manual De Instrucciones página 42

Setting up an additional LAN-connected computer
This section describes how to set up a computer so that you can use the machine that has
already been set up using another computer to connect to a wireless or wired LAN. This setup
procedure only requires settings to be performed on the client computer.
Important
Follow this procedure only when the machine has already been connected to a wireless or wired
LAN. If the machine has not been connected to a network yet, see "Setting up for use over wireless
LAN" on page 27 or "Setting up for use over wired LAN" on page 33 depending on your connection
type.
Note
If MAC or IP address filtering is configured to restrict access to the machine, make sure
beforehand to register those addresses of the computer you are setting up.
To do this, use the Canon IJ Network Tool on a computer that is already set up.
Make sure that the computer you are setting up is NOT connected to the machine via a USB
cable. This setup procedure does not involve connecting the USB cable.
For wired LAN connections, make sure that the machine is connected to the network with a LAN
cable.
1
Turn on the machine.
It takes about 40 seconds until the POWER lamp
lights up green.
Important
This step should follow from step 4 in "Installing the
Software" on page 24. If the Setup Method screen
has not displayed yet, go back to the procedure in
"Installing the Software" on page 24 to complete the
installation of the software.
2
On the Setup Method screen, select Set up
only the computer and click Next.
Setting Up the Machine and the Computer (Windows) 39